Auto repair automation
Automate Customer Approvals for Auto Repair
Get estimates in front of customers fast, with photo evidence and one-tap approval, so vehicles stop sitting on lifts.
Why it pays
Improve approval speed without an advisor glued to the phone
Every hour a customer takes to say yes is an hour a lift sits loaded with unsold work. Advisors leave voicemails, wait, and call again while the day's schedule slips. Automation sends the estimate by text with photos and plain explanations, nudges politely if it sits unread, and escalates stalled approvals to your advisor with the full history.
The build
What the finished system does
01
Send with evidence
Approved-to-send estimates go out by text with inspection photos and a plain explanation of each line.
02
Capture the decision
Customers approve or decline each line, and responses write back to the repair order instantly.
03
Chase politely
Undecided estimates get scheduled nudges, and silence past your limit escalates to your advisor.
04
Update the floor
Approved lines move the job to ready-to-work and notify the tech, so bays keep turning.
How it lands
From sore spot to steady state
- 01
We map how approvals happen today, from estimate sent to yes, including where customers go quiet.
- 02
We baseline time-to-approval and approval rate, then set a first-release target with you.
- 03
We run it against real estimates with your advisor reviewing every message before it sends.
- 04
We launch with one advisor's board, watch the numbers, then roll out to the whole shop.
Wired in, not bolted on
Built around the tools you already run
Your existing software stays. We plug into it, set the limits of what runs unattended, keep a record of what the system did, and make sure a person sees anything strange.
- Shop management
- Phone and SMS
- Parts supplier portals
- Accounting
Questions
The questions we hear first
Which parts of the approval chase can be automated?
The sending, the reminders and the record keeping. Texting the estimate with photos, nudging when it sits unread and writing decisions back to the repair order all run on their own. Negotiations and judgment calls route to your advisor.
Will it work with the estimates our current system produces?
Usually, yes. We read estimates from your shop management system rather than making you write them somewhere new. If your platform has no usable interface, we find that out during the walkthrough, before you spend anything.
How do we know it is working?
Two numbers. Time from estimate sent to decision, and the share of estimates that get a decision at all. We baseline both before launch and report them per repair order after, so the change is visible.